POLYBRON 704

DESIGNATION	POLYBRON 704 ANTI-CORROSION Paint with Zinc Metal
APPLICATION	Indoor and outdoor anti-corrosion complementary coat.
LOCALIZATION	Iron metallic structures exposed to bad weather and chemical attacks which lead to rust development. Ferrous substrates, in marine and industrial environments. - Marine, chlorinated, and oxidising environment - Crude oil and processed products storage tanks - Protection of sub water structures - Metallic works, oil platform bracings, tanks, constructive works, chemical industry.
SUBSTRATES	Iron metallic and galvanized substrates, ferrous or non ferrous previously treated substrates. Old coatings : Make sure of the old protection adhesion, and its compatibility with the primer. Do not use on aluminium substrates
PROPERTIES	Paint base made with metal zinc, specifically treated for anti-corrosion, alone or as a complementary of primer POLYBRON 703. Highly efficient sacrificial protection for severe conditions (electrolytic and chemical oxidising). Outstanding adhesion on safe metal and primer POLYBRON 703. Mat metallic aspect. Polyurethane binder : fast drying and high resistance to chemicals.
SUBSTRATE PREPARATION	The substrates that are very corroded have to be sandblasted or gridded to degree DS 2 or DS 2.5. They must be perfectly clean and free from grease and dust. Adhesion reinforced by impregnation with primer POLYBRON 702 A or POLYBRON 703.
APPLICATION	- Manual application : with roll or brush - Spray painting : maximum thinning with 10% to 20% of a polyurethane thinner. Do not apply if hygrometry is >85%. Minimum temperature for application : 5°C. The surface temperature must always be 3°C over dew point temperature, according to temperature and humidity parameters. Allow to dry 2 to 12 hours before covering with the finishing coat of POLYBRON 705. Maximum interval time with complementary of finishing coat : 48 hours.
EFFICIENCY	Average consumption : 300 to 400g/m² Drying @ 20° and 65% Relative Humidity Dust free : 15 minutes Dry : 1 hour Interval time for additional coat : 2 hours
PRECAUTIONS FOR USE	- This product contains harmful and flammable isocyanates. - Flammable product, do not smoke, do not use near any fire source. - Keep away from children - Keep away from food products - Irritating product for skin and eyes :If any contact with skin, quickly rinse with water and soap or detergent ; If any contact with eyes, rinse with running fresh water
TECHNICAL DATA	Binder : Solvented aromatic polyurethane resin Colour : Metal green/grey Aspect : Mat Density : 1.4 Theoretical Dry Extract : 65% Flash Point : >21°C
SHELF LIFE	Shelter the closed packs in a dry, temperate and ventilated place. Avoid frost and temperatures > 30°C. Maximum shelf life : 6 months.
REGULATIONS	- Road and Maritime Transport : RTMD Class 6.1 Art.723/Groupe 61310 - European labelling : R/20, R/36/37/38, R4 - AFNOR Norms 36005 Famille 1 Class 6A

Information and recommendations contained in this data sheet are the result of experience gained under controlled circumstances and today knowledge. Their accuracy and completeness under the actual conditions of any intended use are not guaranteed and must be determined by our approved applicators since application is beyond control. Disclaims and any liability in excess of what is stated therein for results obtained, injury, direct or indirect damages. Total or partial reproducing of this document can only be made with our express agreement.